Your single point of reference for all your Geotechnical Inquiries

Equipment

Total Items found:
<p>The EFO is a 70-mm long fiber optic strain gauge designed to be embedded in concrete. It consists of a stainless steel body, with two flanges for better adherence to concrete.</p><p>The sensor is based on Fabry-Perot interferometry. The strain gauge is ...
<p>The Model 4000 Strain Gage is designed primarily for arc welding to steel structures such as tunnel linings, excavation bracing, piles and bridges. The gage has a 150 mm gage length (longer or shorter versions are also available), a 3000 µε range and a ...
<p>These Strain Gages are designed for direct embedment in concrete. The 4200 (standard model) has a 153 mm gage length and 1 με sensitivity and is commonly used for strain measurements in foundations, piles, bridges, dams, tunnel linings, etc. The 4210 has ...
<p>The Concrete Surface Mount Strain Gauge measures strain in concrete members. It consists of a coil assembly, Vibrating Wire element and two groutable anchors to embed the unit in the concrete structure to be monitored. O-ring seals between the protective ...
The Model 4425 Convergence Meter is used to monitor closures in underground excavations, tunnels, etc. It is comprised of a spring tensioned transducer, turnbuckle, connecting rod (stainless steel, fiberglass or graphite), rod clamp, and a pair of stainless ...
The Model 4430 Deformation Meter with flanged ends is designed to measure longitudinal deformation in dams and embankments. It can also be grouted or held in place by hydraulic anchors to measure deformations in boreholes (over the gage length). Gage lengths ...
<p>The DiTeSt HDPE Strain sensor is a unique sensor for the evaluation of distributed strain over several kilometers.</p><p>The DiTeSt HDPE Strain sensor is used in a wide range of applications that require distributed strain sensing, such as soil movement ...
<p>The SMARTape strain sensors are designed for distributed deformation (average strain) monitoring over long distances, using BOTDR / BOTDA (Brillouin scattering) technologies. It is used for surface installation on smooth surfaces or embedding into composites.</p><p>The ...
<p>The Model 3900 Embedment Strain Gage is designed for the measurement of dynamic strains in concrete structures, earth fills and soils. It comprises a full bridge strain gaged proving ring coupled, between two flanges, with a spring and shaft. When the flanges ...
<p>The Model ST-350 Dynamic Strain Transducer is used for structural testing and recording strains on steel structures, post-tensioned and pre-stressed concrete structures, etc., and for any structure in which a short-term live-load can be applied. The Model ...