Your single point of reference for all your Geotechnical Inquiries

Equipment

Total Items found:
<p>The 4-20mA Piezometer is designed for accurately measuring pore water pressures in fully or partially saturated soil and rock. The transducer is fitted with a sintered Stainless Steel filter disc and is available as a vented (gauge) piezometer or a non-vented ...
<p>The Model 4500AR “Autoresonant” Piezometer is designed for use with existing data acquisition systems incapable of reading standard (pluck and read) vibrating wire sensors. It can also be used where low frequency (&lt; 20 Hz) dynamic measurements are required. ...
<p>The Casagrande Piezometer Tip is used with the Solinst Model 101 Water Level Meter to monitor subsurface water levels. The piezometer tip, attached to PVC riser pipe, is placed in a sand zone then sealed to the surface with a bentonite grout. The Water ...
<p>RST’s Casagrande Standpipe Piezometer tip consists of a slotted PVC body that encloses and protects a porous plastic filter element. A CPVC body is available for leachate extraction. The Casagrande Standpipe Piezometer is mainly used for measurement of ...
<p>The Model 4500DP Drive Point Piezometer has the transducer located inside a housing with an EW drill rod thread and removable pointed nose cone. This model is ideally suited for use in peat and soft clays. The piezometer may be recovered at the end of the ...
<p>Fully grouted installation permits multiple piezometers to be simply and reliably installed in a single borehole. The piezometer string and grout pipe are placed in the borehole and cement-bentonite grout is pumped until the borehole is filled.<br>Multi-point ...
<p>The Model 4500HD Heavy Duty Piezometer is designed for direct burial in fills and dam embankments. The 4500HD is used in conjunction with heavily armored cable to withstand earth movements during construction. Recommended for use in earth dams.<br>Specifications<br>Standard ...
<p>The Heavy Duty Vibrating Wire Piezometer accurately measures pore water pressures in fully or partially saturated soil. The heavy duty design prevents case stresses from affecting readings in extreme installations (dams and high ground stresses). The transducer ...
The Geonor M-600 series piezometers are vibrating wire sensors which are installed by pushing into soft and loose soils without having to drill or borehole. As with all other Geonor vibrating wire piezometers, the M-600 series offer the maximum relibility ...
<p>The 4500HT Series High Temperature Piezometers are designed for monitoring downhole pressures and temperatures in oil recovery systems and geothermal applications, where the temperature may be as high as 250&deg;C. These sensors are supplied with either ...