The CP standpipe piezometer is a filter element that is attached to a riser pipe. When installed as a piezometer, the filter is located in a sand intake zone at the location where pore-water pressure is to be monitored. A bentonite pellet or chip seal is placed over the sand intake zone and the remaining borehole is backfilled with grout.

A monitoring well installation consists of a filter-element attached to a riser, backfilled with sand to within a few meters of the ground surface. A bentonite seal at the surface prevents runoff water flowing into the monitoring well.

The CP1 consists of a porous plastic filter inside a perforated rigid PVC body. The CP15 is a crush resistant porous plastic filter. Both piezometers are used with rigid PVC riser pipes.

Water enters the riser until the water pressure inside the filter equals the water pressure in the soil. A water level indicator can be then used to measure the depth of water.

The CP15 can be used in combination with the PWS piezometer if continuous monitoring is needed.

Roctest Ltd.
680 Birch Street
Saint-Lambert, Quebec
Canada J4P 2N3
Tel: +1 450 465 1113
Toll free: 1 877 762 8378
Fax: +1 450 465 1938