Your single point of reference for all your Geotechnical Inquiries

Latest Geotechnical Equipment

Total Items found:
<p>The apparatus is used for determination of setting time of the mortar fraction of fresh concrete. The apparatus consists of a spring loading device which is graduated from 2 to 150lbs, supplied complete with a set of needle points of 645, 323, 161, 65, ...
<p>The test covers the determination of the consolidated drained shear strength of a soil material in direct shear. Direct Residual Shear Machine is motorized and floor mounted. Supplied with carriage assembly load hanger and integral 10:1 lever loading device ...
<p>TS-0865 In-situ CBR Test Apparatus, 45 kN capacity, is used for the in-situ determination of the bearing capacity of soils used in road construction.<br />The set consist of:<br />- 45 kN capacity mechanical jack with ball seating,<br />- 50 kN capacity ...
<p>Used to determine the specific gravity of hydraulic cement and lime. Glass flask 250ml capacity, with graduated neck from 0 to 1 ml and from 18 to 24 ml in 0.1 ml graduation with accuracy of 0.05ml.</p>
Filed under: Laboratory Testing -  Cement
<p>The apparatus is designed for determination of setting time of fresh concrete for field and laboratory use.<br />Stainless steel plunger 32.3 mm&sup2; (1/20 inch&sup2;) area; plunger graduated 0-5 MPa or 0-700psi. </p>
<p>The apparatus consist of a load frame 60 kN capacity with a hydraulic loading ram actuated by a hand pump. The frame is adjustable to allow for testing samples up to 102 mm dia. A ruler assembled on the frame allows for direct measurement of the distance ...
<p>Used in the field for penetration resistance/compaction of fine grained soils. The penetrometer is spring loaded with direct reading in kg on a sliding rod.<br />Complete with 9 interchangeable stainless steel needles in the following diameters: 4.52 - ...
<p>When the water content of a fine-grained soil is reduced below the plastic limit, shrinkage of the soil mass continues until the shrinkage limit is reached. This method of test covers the determination of the shrinkage limit, shrinkage ratio, volumetric ...
<p>The test method is a mechanised variation of the slump test for the determination of workability of fresh concrete by performing vibration to concrete after removal of the slump cone. The assembly is mounted upon a small vibrating table operating at a fixed ...