Your single point of reference for all your Geotechnical Inquiries

Equipment tagged with [Total Pressure Cells]

Total Items found:
<p>The Model 4800 Earth Pressure Cells are designed to measure total pressure in earth fills and embankments. All cells consist of two circular stainless steel plates welded together around their periphery and spaced apart by a narrow cavity filled with de-aired ...
<p>The Model 4820 Jackout Pressure Cells are used to measure earth pressures on slurry walls. They are designed to fit inside a plate which is pressed against the side of a slurry wall excavation using a hydraulic jack arrangement. This method of installation ...
<p>The Model 4855 Pile Tip Pressure Cell is used to measure pile-tip loads in cast-in-place concrete piles (caissons). Like the Model 4810, the Pile Tip Pressure Cell has a thick upper plate. The cell is manufactured to be close to the diameter of the pile ...
<p>The Model 4830 Push-In Pressure Cell is designed to be pushed in place for the measurement of total pressures in soils and earth fills. Where effective stress is required, the cell is fitted with an integral piezometer. A thread is provided on the end of ...
<p>The Model 4830 Push-In Pressure Cell is designed to be pushed in place for the measurement of total pressures in soils and earth fills. Where effective stress is required, the cell is fitted with an integral piezometer. A thread is provided on the end of ...
<p>Strain Gauge Load Cells incorporate from 8 to 16 high output electrical resistance strain gauges in a full bridge configuration that are bonded to a high strength steel or stainless steel spool. This arrangement compensates for both temperature effects ...
<p>Total Earth Pressure Cells are designed to measure stress acting on plane surfaces. The TP-101 series Total Earth Pressure Cells are constructed from two circular stainless steel plates, welded together around their periphery. The annular space between ...
<p>TPC-4000 series Total Earth Pressure cells are designed to measure total pressure (effective stress and pore water pressure) in soils and at the interface between structures and the wall of excavation. They are constructed from two stainless steel plates, ...
<p>The total pressure cell is formed from two circular plates of stainless steel. The edges of the plates are welded together to form a sealed cavity, which is filled with fluid. Then a pressure transducer is attached to the cell. The cell is installed with ...
<p>The TPC cells consist of a sealed distribution pad, composed of two plates welded together around the periphery and filled with de-aired oil. The pad is connected via a length of steel tube to a pressure transducer. Variation in oil pressure resulting from ...