Your single point of reference for all your Geotechnical Inquiries

Equipment tagged with [Vibrating Wire Strain Gauges]

Total Items found:
<p>The Model 4000 Strain Gage is designed primarily for arc welding to steel structures such as tunnel linings, excavation bracing, piles and bridges. The gage has a 150 mm gage length (longer or shorter versions are also available), a 3000 µε range and a ...
<p>The Concrete Surface Mount Strain Gauge measures strain in concrete members. It consists of a coil assembly, Vibrating Wire element and two groutable anchors to embed the unit in the concrete structure to be monitored. O-ring seals between the protective ...
<p>The EM is composed of two end pieces joined by a tube that protects a length of steel wire. The wire is sealed in the tube by a set of O-rings on each end piece. Both end pieces have a flat circular flange to allow transfer of concrete deformation to the ...
<p>The Model 4910 Instrumented Rockbolt comprises a vibrating wire strain gage located inside a short length of standard threaded rockbolt or rebar. This short length is then connected via a coupling to a longer length of the same bolt material. The instrumented ...
<p>The Model 4900 Vibrating Wire Load Cell consists of a cylinder of high-strength steel with 3, 4 or 6 vibrating wire strain gages located around the circumference of the cell. Loads applied to the cell are measured by the vibrating wire strain gages. The ...
The P-520M frequency counter is the read-out instrument for all GEONOR vibrating-wire transducers. The counter is designed for use in situ and is enclosed in a rigid aluminium housing. The display shows the frequency of vibration in Hz, which has to be calculated ...
<p>The SM-2 consists of a length of steel wire tensioned between two end blocks and protected by a connecting tube. The exterior forces applied on the end blocks modify the tension in the wire, hence its resonant frequency, which is read by a built-in electromagnet. ...
<p>The <strong>SM-5</strong> is composed of two end pieces joined by a tube that protects a length of steel wire. An electromagnet is placed in a protective hou sing located at the center of the tube. The exterior forces applied on the strain gauge modify ...
<p>The Vibrating Wire Arc Weldable Strain Gauge measures strain in steel members. It consists of a coil assembly, Vibrating Wire element and two weldable anchors. The Strain Gauge incorporates O-ring seals to provide waterproofing, and allows the tube to remain ...
<p>The Vibrating Wire Embedment Strain Gauge is used for measuring strain in mass concrete. The 150mm long gauge, which is made from stainless steel, may be pre-attached to rebar or by attachment to a 2, 3 or 4 directional rosette, thereby measuring strain ...