Your single point of reference for all your Geotechnical Inquiries

Publications in

Earthquake Engineering

Earthquake engineering is defined as the scientific branch devoted to the protection of society from earthquake hazards. More specifically earthquake engineering is defined as the behavior study of structures and geostructures during and after an earthquake. Geotechpedia provides a plethora of papers concerning earthquake engineering.

Total Items found:
Seismic imaging in thrust-belt environments like the foothills of the Himalayas benefits significantly from interpretive input to velocities used for time and depth migration. With low fold in the near surface, low signal-to- noise ratios on the image gathers, ...
Reference: 9th Biennial International Conference & Exposition on Petroleum Geophysics
This paper provides a comparison between the strong ground motions observed in the Christchurch central business district in the 4 September 2010 Mw7.1 Darfield, and 22 February 2011 Mw6.3 Christchurch earthquakes with those observed in Tokyo during the 11 ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch
This paper investigates the influence of hysteretic characteristics of structures on contents damage. The damage to contents considered was limited to sliding induced damage, excluding rocking induced damage. A single storey structure and contents were modelled ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch
Impact between structures of bridge sections can play a major, unexpected role in seismic structural damage. Linear and non-linear models are developed to analyze structural impact and response of two single-degree-of-freedom structures, representing adjacent ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch
<p>Most of the Egyptian irrigation structures were built many decades ago. Most of these structures may be classified as unsafe structures when making an assessment of their resistance to earthquake loads in accordance with the current specifications. This ...
Reference: Sixteenth International Water Technology Conference, IWTC 16 2012, Istanbul, Turkey
On 4 September 2010, a surface rupturing earthquake (Mw 7.1) struck the Canterbury Plains region in New Zealand's South Island. The Canterbury Plains is a region of relatively low seismicity, and the structure that ruptured was a previously unmapped fault. ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch
In 2004, the GeoNet project operated by GNS Science implemented an internet-based questionnaire. Its aim was to provide an automatic intensity assignment in New Zealand’s Modified Mercalli (MM) intensity scale based on answers to a set of standardized questions. ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch
<p>Approaches that are widely used to characterize propensity of soils to liquefaction are mainly of empirical type. The potential of liquefaction is assessed by using correlation formulas that are based on field tests such as the standard and the cone penetration ...
Reference: MATEC 1 matecconf 0110008 10008 (2012)
In this paper, a loss estimation evaluation for Christchurch CBD, with focus on reinforced concrete (RC) buildings, is conducted with the main aim to improve the reliability of current procedures to support the aforementioned decision-making process. Comparisons ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch
We compare site-specific response spectra and hazard maps from the recently-updated national seismic hazard model (2010 NSHM) and predecessor NSHM of 2002. The new model incorporates over 200 new onshore and offshore fault sources, and utilises newly-developed ...
Reference: NZSEE Annual Technical Conference & AGM, 13-15 April 2012, Christchurch